Edit File: defaults
########################################################## # DO NOT EDIT THIS FILE! # # # # Add files in /etc/pm/config.d/ instead! # ########################################################## # Default method to power down the system when hibernating. # If commented out, the system will use the kernel default as a # default value. # # Check /sys/power/disk for valid values. The default value # will be surrounded by [square brackets]. # HIBERNATE_MODE="shutdown" # Whether we need to post the video card when resuming from # hibernate. You should not normally need to set this. # In the future pm-utils will get this setting from HAL. # # Valid values are "no" and "yes" # HIBERNATE_RESUME_POST_VIDEO="no" # The default sleep/wake system to use. Valid values are: # kernel The built-in kernel suspend/resume support. # Use this if nothing else is supported on your system. # uswsusp If your system has support for the userspace # suspend programs (s2ram/s2disk/s2both), then use this. # tuxonice If your system has support for tuxonice, use this. # # The system defaults to "kernel" if this is commented out. # SLEEP_MODULE="kernel" # These variables will be handled specially when we load files in # /etc/pm/config.d. # Multiple declarations of these environment variables will result in # their contents being concatenated instead of being overwritten. # If you need to unload any modules to suspend/resume, add them here. # SUSPEND_MODULES="" # If you want to keep hooks from running, add their names here. # HOOK_BLACKLIST="" # If you want to unconditionally add parameters to the commandline, # add them here. # ADD_PARAMETERS="" # If you want to ignore commandline parameters, add them here. # DROP_PARAMETERS="" # If you need to synchronize the system clock across a suspend/resume or # hibernate/thaw cycle, set this variable. # NEED_CLOCK_SYNC="true"